Torque Manual

Owner's manual and setup guide.

Owner's Manual

The Torque™ slingshot is a joint project between Mark Seljan and SimpleShot. The result is a perfect EDC slingshot that you'll want with you all the time.

This owner's manual will go over setup of your slingshot and knowledge to make sure you safely and correctly use your Torque slingshot.

Get to know your Torque™ Slingshot

This owners manual will go over setup of your Torque™ Slingshot, and show you how to safely and properly set up and use your slingshot.

_Keep scrolling for the video owners manual that covers setup demonstration!_

The Shooter Side

The Torque can literally be held in any direction with either hand. The Shooter side is whichever side is facing YOU when you're shooting.

The Target Side

The side of the Torque that's facing the target when you shoot whether held left or right handed, right side up or down.

FlipClip X™ for Torque™

The Torque FlipClips are for attaching virtually ANY bandset you'd like.

Switch Tubes in seconds

Originally a dedicated tube shooter, the Torque is still king of the hill for easy tube changes. Just stretch and pop the tube through the slot.

OTT (Over The Top)

The Torque is a dedicated OTT (Over The Top) shooter. The wide fork-tips accommodate large band-sets.

The Lanyard

A simple piece of paracord that attaches to the handle of your Torque frame and secures the slingshot to your frame-holding hand.

Do not shoot stones or rocks from any slingshot.

Rocks – no matter how round they look – shoot erratically and shooting them may damage your slingshot and bands.

Due to the uncontrollable nature of shooting non-spherical projectiles, shooting a rock from a SimpleShot slingshot voids any / all warranties.

TORQUE™ SLINGSHOT SETUP INSTRUCTIONS

Step one: Install the Lanyard

It is critical to always have the lanyard securely wrapped around the wrist when shooting. Serious injury can result from improper use, so make sure you ALWAYS install and use the lanyard when shooting your slingshot!

STEP 1. Thread one end of the lanyard through the hole in the end of the Torque frame

STEP 2. Tie a simple overhand knot with BOTH tag ends of the lanyard.

STEP 3. Pull tightly to secure the knot (adjust the position of the knot to vary size of the lanyard.

STEP 4.Check the lanyard to make sure it is secure.

ALWAYS wear the lanyard securely when shooting! The lanyard should firmly but not tight. It should be secure enough to prevent the frame from ever slipping from your hand.

Get to know FlipClipsX™ for your Torque™

Every FlipClip has a "tooth."

This upper side of the clip has a "tooth" perfectly machined to fit your Torque.

Left and Right Components.

The logos engraved on each clip will show you which is which.

Flip Clip Orientation.

The logos should be on the INSIDE of the fork with the bands over the top.

Step two: Installing Bands (OTT) On Your Torque™ Slingshot

The Torque™ Slingshot is designed to shoot Tubes and Flat Bands OTT (Over The Top).

2.1: Installing Tubes OTT

Step 1.

Stretch the tube a bit to narrow it down to fit through the slot.

Step 2.

Pull the loop through the slot in the Torque™ fork-tip. It's that simple.

Step 3.

Ensure the loop is seated in the center of the fork-tip in the tube groove.

Step 4.

Never pull the tube back with the tube around either side of the fork-tip.

ATTENTION:Step 4, Pull the tube back with the tube around either side of the fork-tip could unhook your tube, and potentially cause serious injury.